leantranspo® - Transfer, Handling, Pick & Place

Pick & Place-system

For the horizontal drive (X- or Y-stroke), a lifgo^® linear unit with linear gear rack is placed on the carrier. A lifgo^® linear unit is mounted on it for the Z-stroke.
Qualities of the application: very fast and very precise

2-axis-portal, variable

2-axis transfer with lifgo^® linear for each axis. Grippers, clamps, vacuum devices, or other auxiliary
devices can be installed at the ends of the gear racks.

2-axis-transfer with gripper function

This standing 2-axis transfer is used as part feeder. A horizontal stroke axis, a gripper or closing axis, synchronous on both sides toward the middle. It can be used as a walking beam and is also available as a 3-axis transfer with horizontal and vertical stroke and synchronous closing axis.

2-axis positioning table with auxiliary equipment on request

Standing 2-axis positioning table for high loads and fast travel speeds. A Z-axis or other accessories can be mounted. A suspended version is also possible.

4-axis system with rotary head and suction pad

.This 4-axis "pick & place" system with linear motion has a fifth axis which is used as an off-center rotary axis with a suction pad or magnet. This application is for receiving area-optimized pre-cut parts
(sheet metal, etc.) and for stacking the parts congruently on the opposite pallet.

2-axis portal with 2 vertical axes

Portal with two lifgo^® linear units and an additional lifgo^® guide. Two lifgo^® units are installed on it for the Z-axis. Auxiliary devices are installed on the ends of the gear racks.